Skip to main content

Know How – Technical Bulletin – TB-NST-01


01 Jul 2021

Category:

FITMENT CHALLENGES – WISHBONE RH/LH FORD FIESTA 1.4 01-08

THE PROBLEM

When fitting wishbones to an application, the narrowness of the mounting location for the wishbone bushes can make installation difficult. To overcome this issue, follow the steps below.

The Solution

1. CLEANING

Before fitting the wishbone bush, clean the location hole (circled) with a wire brush.

2. Removal

Apply sufficient force to push the wishbone bush into the location hole. This will align the bushes and the ball joint for fitment.

RECOMMENDATIONS

After fitting a new steering and suspension part, check your steering geometry. Your vehicle may not appear to be exhibiting excessive tyre wear on immediate inspection, but a misaligned geometry could lead to excessive tyre wear over time.

Become a NAPA Stockist   Download PDF Guide

Previous post

Next post

View all posts

Rotating Electrics Fault Diagnosis Guide

Troubleshooting common misdiagnosis problems with Rotating Electrics. The alternator generates electric current to replace power...

Read More

Timing Chains Tensioner Upgrade - NCK4008 & NCK4034

An upgraded tensioner is available with NAPA Timing Chains. In accordance with BMW OEM standards,...

Read More

10-Tooth vs. 12-Tooth Pinion Drive - NSM1521

Possible visual discrepancy between NAPA Starter Motor and OE. NSM1521 has a 12-tooth pinion drive,...

Read More